Hello dear readers today I went somewhere and I noticed there were active WiFi routers nd hotspots all around and I decided to you know access them as I couldn't go asking for the passwords well today I wish to tell you how I did it.
~First method.
Step 1: Firstly, if your android phone isn't rooted, try to root it.
Step 2: Then download and install bcmon, it's essential because it helps monitor mode on your broadcom chipest that helps in the PIN Cracking.
Step 3: After installation, run the app and tap "monitor mode" option.
Step 4: Download and Install Reaver app which helps to crack the WPS Pin to retrieve the WPA2 passphrase.
Step 5: After installation of reaver app, launch it and do an on-screen confirmation, which is, confirming that you're not using it for illegal purpose, then tap the APN or access point you'd wish to crack and continue. Most times, you might need to verify monitor mode to proceed, and this would cause the bcmon to open again.
Step 6: Verify your settings and also make sure that you've checked the Automatic Advanced settings" box.
Step 7: Finally, start cracking process by tapping start attack, at this final stage, it can take from a couple of minutes to a few hours for the cracking of WPS to be successful.
~Second method
Step 1: make sure your device is rooted.
Step 1: make sure your device is rooted.
Step 2: Then download and install bcmon from the link above it's essential because it helps monitor mode on your broadcom chipest that helps in the PIN Cracking.
Step 3: After installation, run the app and tap "monitor mode" option.
Step 4: Then tap the "Run bcmon terminal" option and type "airodump-ng" and Enter. Once the airodump loads finish, you would be directed to the prompt command in which you're to type "airodump-ng wlan0" then tap the Enter button.
Step 5: In this stage, a Mac address would appear, in which you're to jot down.
Step 6: Start scanning the channel by collecting information from the access point before attempting to crack the password, then type, "airodump-ng -cchannel#--bssidMAC address-w output ath0" and tap enter, then it would start scanning, try scanning till it reaches 20,000 - 30,000 packets.
Step 7: To finally crack the password, return to the terminal, but make sure you've reached the suitable number of packets, then type "aircrack-ng output*.cap" and tap enter at the terminal.
Step 8: Once the password is cracked successfully, you would receive a message alerting, 'Key Found' and would display the key in hexidecimal form. So when entering the key, make sure you eliminate the dots '.' or double dots ':', i.e if it displays 12:34:56:78:90, then enter 1234567890 as the code.
Disclaimer: Please I won't be held responsible for any illegal activity this tips is used for, it's just for knowledge sake.
Post a Comment